For Sponsored Posts & Articles, please email us on 📧 networks.baseline@gmail.com

Add ISE as a RADIUS Server for Wired 802.1X

Add ISE as a RADIUS Server for Wired 802.1X

In this article, we will going to discuss how to add IISE as a RADIUS Server for Wired 802.1X

Fig 1.1- Meraki Basic Topology

Below are the 10 steps to add ISE as a Radius server for Wired 802.1x. Earlier we discuss for Wireless.

Step 1 Select the wired network for use with ISE from the Network: drop down menu.

Step 2 Under the Configure menu in the Meraki dashboard, select Access policies.

Step 3 Select Add an access policy.

Step 4 Give the new policy a name. (For example, ISE).

Step 5 In the Host field, enter the IP address of the ISE node. 

Step 6 In the Port field, enter 1812.

Step 7 In the secret field, enter the shared secret.

Step 8 Set RADIUS testing to RADIUS testing disabled.

Step 9 If desired, enter the Guest VLAN for use when users fail 802.1X authentication. 

Step 10 Click Save.

Other Cisco Meraki Articles
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Cisco Catalyst 9k on Meraki Dashboard - The Network DNA
Cisco Meraki: Add ISE as a RADIUS Server for Dot1x SSID - The Network DNA
Part 1: 10 Basic interview questions on Cisco Meraki - The Network DNA
Cisco Meraki: Configure Meraki Wireless Group Policy with ISE - The Network DNA
Cisco Meraki : Add ISE as a RADIUS Server for Guest SSID - The Network DNA
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

No comments

Note: Only a member of this blog may post a comment.