Fortinet SDWAN resources

 FORTINET SDWAN

• Fortinet SDWAN LAB Guide
  
• SD-WAN designs principles 
  
• Basic SD-WAN configuration
• Configuring SD-WAN from CLI 
  
• Add a new WAN link to an existing SD-WAN setup. 
  
• SD-WAN configuration for IPv6 
  
• SD-WAN zones 
  
• Performance SLA 
  
• SD-WAN rules 
  
• SD-WAN Advanced routing 
  
• VPN overlay with SD-WAN 
  
• Advanced SD-WAN configuration 
  
• Configure IPsec VPN with SD-WAN 
  
• Manually assign outgoing interface In SD-WAN setup 
  
• Multiple default routes where SD-WAN rules are not preferred 
  
• SD-WAN support for ADVPN 
  
• VXLAN with SD-WAN 
  
• SD-WAN integration with OCVPN 
  
• Gateway configuration for DHCP and PPPOE SD-WAN members 
  
• Configure DHCP relay traffic to use SD-WAN rules 
  
• NetFlow and SFlow SD-WAN support 
  
• SD-WAN primary and backup ipsec tunnel Scenario 
  
• Maximize Bandwidth Strategy in SD-WAN 
  
• SD-WAN enhanced health check options 
  
• SD-WAN rule with settings as ‘set mode load-balance’ 
  
• Traffic shaping with dedicated SD-WAN interface members.
• SD-WAN Bandwidth monitoring service 
  
• How to configure the hold downtime to support SD-WAN service strategies 
  
• Identity-based routing with SD-WAN 
  
• SD-WAN rule matching for ISDB and application ID 
  
• Enable and disable SD-WAN options 
  
• Enabling auxiliary session with ECMP or SD-WAN
• Locally generated traffic for DNS not matching SD-WAN rule with source address configured 
  
• SD-WAN interface as HA ping server monitor interface 
  
• How to push gateway correctly in SD-Wan rules.
• SD-WAN link status update through automation stitch feature 
  
• How to send logs to Syslog server over SD-WAN 
  
• Policy Routing Enhancements for Traffic in Reply Direction 
  
• How to add Mac address in SD-WAN rule 
  
• How to use IPsec tunnel interface on Performance SLA 
  
• Configuring Zero Value for Volume or session based SD-WAN Algorithm 
  
• FortiOS SD-WAN SLA Tie Break Feature Overview 
  
• How to configure source IP for Secure SD-WAN Performance SLA 
  
• Using 'probe-packets disable' in SLA Performance for SD-WAN 
  
• How to reset SD-WAN pie chart usage statistics 
  
• SD-WAN Rules - link-cost-threshold attribute 
  
• Routing in FortiGate (route-lookup-process) 
  
• Routing Change and Session Fail-over with SD-WAN 
  
• Load balancing per-rule 
  
• How to set a scheduled speed test for a SD-WAN Network Monitor 
  
• How to use BGP and SD-WAN for advertising routes and path selection in FortiGate 
  
• How to load balance traffic between two interfaces via static routes 
  
• SD-WAN log explanation for 'conservative status with limited ablity to receive new sessions' 
  
• Differentiated Services Code Point (DSCP) support for SD-WAN health check probe packets 
  
• Use SD-WAN intelligence for selecting interface to use in communicating with Fortiguard servers 
  
• Functionality of 'set update-cascade-interface' under 'config healthcheck; in SD-WAN 

⭐Fortinet SDWAN Troubleshooting 👇

• Troubleshooting SD-WAN 
  
• SD-WAN related diagnose commands 
  
• SD-WAN event log subtype 
  
• The SNMP OID for the SD-WAN 
  
• Error in adding interface to SD-WAN 
  
• How to trace-route using SD-WAN interface 
  
• SD-WAN performance SLA for IPsec interface shows down 
  
• VIP not working with SD-WAN reply traffic causing issue 
  
• Command to find historic log of the performace SLA of SD-WAN member 
  
• ECMP load-balancing mode CLI setting will disappear when SDWAN status enabled 
  
• SD-WAN link status update through automation stitch feature 
  
• Prevent self-originating traffic egressing with certain SD-WAN rules 
  
• Diagnostic commands to check the status of the SD-WAN link 
  
• Unable to access SSL-VPN bookmarks when using different SD-WAN zone 
  
• NPU offloaded session not failing over according to SD-WAN rule SLA 
  
• FortiGate source-ping using SD-WAN rules 
  
• WAN interface bandwidth log 
  
• PPPoE interface used in SD-WAN rules is not forwarding any traffic 
  
• Internet is not working with one of the SD-WAN member when IP pool is called in the policy 
  
• How to associate a NAT pool (IP pool) to a physical interface of an SD-WAN 
  
• Factory default health checks for performance SLA configuration 
  
• To prevent forwarding traffic gateway change of SD-WAN member interfaces due to ICMP-Redirect 
  
• Locally generated traffic for DNS not matching SD-WAN rule with source address configured 
  
• BGP SD-WAN Route-tag supersedes most specific route. 
  
• FortiGuard update fails when having IPsec tunnel in SD-WAN members 
  
• Functionality of 'set interface-select-method' for local-traffic with SD-WAN 
  
• SLA Logging